Dawn II

System Details

Component Type Brand Product

Notes

This is the first time I've made an acrylic case and also the first time I've sleeved an entire PC. I usually cheat and get sleeved extensions :) The case is made of 1/4inch acrylic and I used acrylic "glue" to put it all together. I set it up on what I believe is called a positive pressure air flow design, with only the 2 front fans as intake and a grid of 1/2inch holes along the back and in the front side of the motherboard tray right behind the fans with my PSU pulling air through from the bottom and then out. The mother board tray is fully removable for when I have to do upgrades and such and I made custom acrylic feet to raise the motherboard up off the tray by almost an inch. The hard drive cage is from my old Thermaltake case and I just drilled the rivets and cut the 2 small welds to get it out and made a couple of acrylic blocks to kind of pinch it and hold it in place. Thanks for checking out my system and any comments or suggestions are appreciated, thanks all.

Comments

No comments have been posted about this system.    Total Comments 0

Post new comment